![\"Safety](\"https:\/\/foxbatpilot.files.wordpress.com\/2015\/04\/safety-011.jpg?w=627\")
Probably the single most important factor in choosing an aircraft\u00a0is safety – and it’s usually the most overlooked and under-rated aspect of an LSA.<\/p>\nProbably the single most important factor in choosing an aircraft\u00a0is safety – and it’s usually the most overlooked and under-rated aspect of an LSA.<\/p>\n
I remember (old geezer that I am) when motor car companies said that ‘safety doesn’t sell cars’ and they concentrated on looks, acceleration, top speed,\u00a0road holding, even comfort. Volvo was just about the only company selling safety in their vehicles and as a result gained a reputation as a safety conscious, old people’s car, which has taken years to shake off. If they ever have.<\/p>\n
Nowadays, all car manufacturers – not just Volvo – tell you how crash-resistant their vehicles\u00a0are, how many airbags they have, how anti-skid the brakes and steering are. They have things like traction control and other electronic devices to get you out of the trouble your excess speed or other stupid behaviour just got you into.<\/p>\n
So, what about Light Sport Aircraft safety?\u00a0There are two main aspects to consider: primary and secondary safety. ‘Primary’ refers\u00a0to the way the aircraft is designed to reduce the likelihood of an incident or accident happening in the first place.\u00a0‘Secondary’ refers\u00a0to the aspects of the aircraft which reduce the effects of \u00a0an incident or accident.<\/p>\n
Aircraft primary safety can broadly be grouped into ground handling, take-off, stalling & spinning, and landing.<\/p>\n
On the ground Whereas most taildraggers steer via feet-operated differential main wheel brakes with\u00a0castering (and sometimes steerable) tailwheels, most modern nose wheel aircraft steer more directly through rudder pedal couplings to the nose leg. This has the\u00a0advantage of\u00a0more directional control when the wheel is on the ground. But a potential\u00a0disadvantage when landing in crosswinds, as the nose wheel may not be pointing in your direction of travel\u00a0when it touches down. In the air Stalling<\/strong><\/p>\n Now look at the relationship between stall speed and flap limiting speed.<\/strong> I know of at least one LSA where the stall speed without flap is less than 10 knots below the flap limiting speed. Think about it: you’re coming in to land and you can’t lower flap (eg) until 55 knots. Your\u00a0stall speed without flap is 45 knots. So you don’t have much margin of speed in which to get the flaps down. Personally, I’d want\u00a0an aircraft where the ‘clean’ stall speed is at least 40-50 knots below\u00a0the flap limiting\u00a0speed.<\/p>\n Spinning Landing When landing, also look out for elevator authority. At least one LSA ‘runs out’ of elevator at landing speeds only slightly slower than its pilot manual advises. This can lead, at best, to a heavy landing; at worst to broken landing gear, because you can’t arrest the downward momentum without applying quite a lot of power. Usually, the reason the elevator loses its bite at slower speeds is because its travel has been\u00a0limited so as to\u00a0minimise\u00a0the effects\u00a0of inadvertent stalls – the downside is the loss of elevator authority when landing slowly.<\/p>\n In summary Opinion about ‘pleasant’ and ‘unpleasant’ handling aircraft will always be divided so don’t rely on someone else’s personal preferences. Out there is an aircraft for you – fly as many different types as you can, if possible for at least an hour each. That way, you’ll begin to get the feel of the primary safety characteristics you like.<\/p>\n Next – secondary safety.<\/p>\n","protected":false},"excerpt":{"rendered":" Probably the single most important factor in choosing an aircraft\u00a0is safety – and it’s usually the most overlooked and under-rated aspect of an LSA. I remember (old geezer that I am) when motor car companies said that ‘safety doesn’t sell … Continue reading ![\"Ergonomics](\"https:\/\/foxbatpilot.files.wordpress.com\/2015\/04\/ergonomics-02.jpg?w=627\")
But first – ergonomics
\n<\/strong>Ergonomics\u00a0are a good place to start, because\u00a0if they are wrong for you, it doesn’t really matter about the rest. Start with something completely counter-intuitive: how quick and easy is it to exit in an emergency like an engine fire? How easy is it to release the\u00a0safety belt, open the door and hop out? Think: can I comfortably sit here for 2-3 hours and fly the aircraft? Are you cramped with a passenger on board? Can you still easily operate the controls to their limits with someone else next to you?\u00a0If reaching a control, adjusting an instrument or even just looking outside the aircraft are a chore, these activities\u00a0will soon\u00a0be minimised and put in the ‘can’t be bothered’ basket and as a result, your safety will be\u00a0compromised.<\/p>\n
\n<\/strong>Next, on the ground: how well does the aircraft steer and brake?\u00a0It is well known that taildraggers are trickier to steer and brake than nose-draggers. But less well known is that some nose wheel aircraft can be a bit of a handful too.<\/p>\n![\"Castering](\"https:\/\/foxbatpilot.files.wordpress.com\/2015\/04\/castering-nose-wheel.jpg\")
This can lead to bent or even collapsed nose legs. So some aircraft designers have stuck with (or even reverted to) castering nose wheels, steered by main wheel differential braking – either by feet or hands. This gives slightly trickier ground handling especially when it’s windy but reduces the chances of bent gear when landing cross wind. Castering nose wheels usually have a smaller turning circle than direct\u00a0steering, a particular advantage when back-tracking and turning on narrow runways.\u00a0There are advocates of both systems – try both and\u00a0take your choice.<\/p>\n
\n<\/strong>First, take-off. When applying power for take-off, all single engined aircraft pull to one side due to the combined effects of gyroscopic forces\u00a0from the engine and propeller and sometimes the spiralling airflow over the tail. Some aircraft have the engine offset so that it points to one side or the other to help minimise the pull – which can look a bit odd from some angles. Correcting the pull should be easy, through application of opposite rudder. However, some aircraft have a much stronger tendency to swing than others. Check out this effect and make sure it is controllable – particularly (eg) if the engine pulls to the left and the wind is blowing from the left, both of which will conspire to turn\u00a0you off the runway if you don’t take prompt corrective action.<\/p>\n![\"stalling\"](\"https:\/\/foxbatpilot.files.wordpress.com\/2015\/04\/stalling.jpg\")
What about the stalling characteristics?\u00a0Most LSAs\u00a0stall very benignly, the nose goes down gently and rarely does a wing drop – something caused when one wing loses lift before the other, for a variety of reasons, but usually because the aircraft is being flown out of balance, with the slip ball not centred.\u00a0Stalling with a wing drop is most dangerous when making that low-level turn onto final approach before landing. There are a few aircraft\u00a0which can bite unexpectedly when stalled –\u00a0if you are an experienced pilot and aware of what’s happening, prompt action can save you. But if the characteristic is particularly vicious and\/or you are a low-time pilot, the chances are you won’t survive a finals turn stall with a\u00a0wing drop. Check this aspect of the aircraft with someone familiar with the type and maybe even ask an instructor\u00a0to take you\u00a0up high and\u00a0try stalling in turns.<\/p>\n
\n<\/strong>Spinning is really just a stall with maintained wing drop. When I learned to fly, spin recovery was on the syllabus. The aircraft I started to learn on was a Piper Colt, which was difficult to spin – the best you could get out of it was really a spiral dive. To make sure we knew how to recover properly from a spin, we were all taken up\u00a0in a Beagle Terrier – an excitable little aircraft whose bite was far worse than its bark! Nowadays you aren’t allowed intentionally to spin an LSA and spin recovery training has been replaced with ‘incipient spin’ recognition. Because unintentional spins almost always happen when the pilot’s attention is absorbed with something else, I personally believe\u00a0spin recovery should be taught as part of basic training, even though most (but not all) LSAs are spin-resistant. At least you will learn instinctively to apply opposite rudder to stop the spin and then raise the nose and apply power. Check out how easy it is to spin your preferred LSA – the manufacturer is required to\u00a0have carried out spin testing as part of the ASTM certification programme.<\/p>\n
\n<\/strong>Approach speeds vary a lot with LSAs. Some require at least 65-70 knots down final, others as little as 40 knots. The faster the landing speed, the more wear and tear on the aircraft and the faster things happen if they go wrong. So in the same way you wouldn’t get into a Ferrari to learn to drive, so you shouldn’t get into a\u00a0fast aircraft to learn to fly! Build your skills in slower gentler aircraft before taking on the trickier ones. And anyway, you might find you like going slow!<\/p>\n![\"Landing\"](\"https:\/\/foxbatpilot.files.wordpress.com\/2015\/04\/landing.jpg\")
<\/a>When assessing the aircraft’s landing characteristics, it’s important to check the correct approach speed – take it up to 3,000 feet AGL and try a few stalls. Note the indicated stall speed. Your approach speed\u00a0for a low inertia aircraft like an LSA should be around 150% of that speed – much faster and you’ll float all the way down the runway; much slower and you risk a low-level stall. For example, the Foxbat indicated stall speed in landing configuration at maximum weight is in the low 30’s knots; approach speed therefore should ideally be around 50\u00a0knots. The factory manual actually says 49 knots. With one person and half fuel, stall in the Foxbat is around 26-27 knots – so approach speed can safely be reduced to 40-45 knots.<\/p>\n
\n<\/strong>Ground handling and flight characteristics of all aircraft are a compromise, based on what the designer\/manufacturer is trying to achieve. Undoubtedly, current LSAs are among the safest handling aircraft available – after all, they mostly incorporate the latest computer-aided design techniques, they stall gently and are spin-resistant. But there are still a few mongrels\u00a0among them.<\/p>\n